Duct Fittings Production & Metal Processing Manufacturer From China
Recent Posts
Problems to be paid attention to in the processing of Pressed ventilation elbow
Release time:
Jun 01,2022
When the Pressed ventilation elbow is processed, it is usually carried out at room temperature. The cold drawing produces plastic deformation and then increases the yield strength.
When the Pressed ventilation elbow is processed, it is usually carried out at room temperature. The cold drawing produces plastic deformation and then increases the yield strength. This process is called cold drawing strengthening. The principle of pressed ventilation elbow in the process of cold drawing strengthening is that the defects of the lattice of the elbow increase during the plastic deformation, and the severe deformation of the lattice of the defect will hinder the further slippage of the lattice when the elbow is pushed. The quality and service life of the elbow increase the yield point of the elbow, and the plasticity and toughness decrease. Because of the internal stress generated in the plastic deformation, the elastic modulus of the elbow decreases.
At this time, the cold-drawn steel bars are stored at room temperature for 15-20d or heated to 100-200°C and kept for a certain period of time. This process is called aging treatment. After the aging treatment of the pressed ventilation elbow after cold drawing, the yield point is further improved, the ultimate tensile strength also increases, and the plasticity continues to decline. Due to the reduction of internal stress during the aging process, the elastic modulus can be basically recovered.
It is very important to grasp the stress of the Pressed ventilation elbow. After cold drawing, the push elbow is used as a prestressed steel bar, and the cold drawing stress should be used to dominate. However, after the cold drawing of the steel bar, it is found that the cold drawing rate exceeds the standard value, and the machine can perform it again. The cold drawing rate of the pressed ventilation elbow is also important to determine the operational control.
keywords
Previous Page:
Contact Us
Tel: +86-311-85612775
WhatsApp: +86-15028109230
E-mail: info@ypmachinery.com
Address: 2-201,Fangda Tech Park ,No.266 Tianshan Street, Shijiazhuang City,Hebei Province, China
Our Products
We produce all kinds of metal parts include machine parts, metal stamping, deep drawn, sheet fabrication, welding parts, and assemble products
Follow us
